联络人: 成鹏
联系电话:13823369693
传真号吗: 0755-27873025
地址:广东省深圳市宝安区73区腾骏工业园B座6楼602室
How to use the rescue print head to clean the film
Source: Release time:2019-05-14 Click on the quantity:713
1) Disconnect the printer from the power source.
2) Open the print head and remove the print media and print ribbon from the print unit.
3) Clean the print head according to the recommended print head maintenance procedures.
4) Place the salvaged printhead film on the print channel under the printhead with the smooth side facing down and the printhead facing up.
5) Close and lock the print head.
6) Slowly pull the film completely out of the printing unit.
7) Clean the print head again according to the recommended print head maintenance procedures.
8) Load the print media and ribbon, close and lock the print head.
9) Print multiple labels to check if print quality improves. If print quality does not improve, contact technical support.
Use film to remove dirt and dirt just one time.
Each film can be used up to ten times.
When there are obvious residues or dirt on the film, the glue should be discarded and discarded.